Areas of use@2@2The Strut-Lock range is intended for indoor use. Conventional galvanized systems should not be used in areas subject to corrosion or elevated heat or humidity.@2For installations located in corrosive areas, consult Zip-Clip Technical Department.@2@2Fixing Options@2@2M8 and M10 Strut-Lock systems are available with the following attachment ends:@2LOOP END:@2To create a choke assembly for wrapping anchor points such as fenders or I-beams. Make sure the attachment points are suitable. @2Product code suffix: TPDM820LPS or TPDM1020LPY.@2@2M6 CONCRETE HAMMER FIXTURE:@2BS8539 approved by ETA offering shallow embedment in cracked and uncracked concrete. Make sure the base material is suitable. Contact Zip-Clip for installation details. Product Code Suffix: TPDM820CS or TPDM1020CY.@2@2M8 × 60 Eyebolt:@2@2For connecting to internal thread components (metric only). Make sure the components are compatible to complete the installation. Product Code Suffix: TPDM820THS or TPDM1020THY.@2Other mounting options are available upon request.@2@2Installation@2Strut-Lock installation in a channel - creating a single level trapezoidal bracket:@2@21.Pair with square washer and channel nut.@22 .Place the assembly in the desired channel location.@23.Tighten into position using a suitable wrench by turning clockwise.@24.Return the locking collar. Do not withdraw completely. Push the plunger.@25.Put the wire rope through the plunger at the top of the unit.@26.Adjust the position by pressing the plunger and moving along the wire.@27.Once the trapezoidal bracket is in place, release the plunger and wind the latch. collar up to the shoulder.@28.Fix the trapeze position by turning the locking collar clockwise.@2@2Repeat 1-8. step to create a multi-stage bracket.@2@2Torque setting: It is recommended that the Strut-Lock device is not over-tightened during installation. If it is possible to apply a torque value during installation, it should not exceed 15 Nm.@2@2TO UNDO:@21.Disengage the locking collar.@22.Press the piston.@23.Move the device to the required height.@24.Repeat lock the collar.@2@2PLEASE NOTE:@2@2Always support the load before actuating and adjusting the piston