THE TRY-LOCK SYSTEM is designed to suspend services from a single-point suspension. The aim of this support is to reduce the amount of material that is used to build a support. Try-Locks are fitted to the intended application using carabiners and then coupled to a chosen Zip-Clip vertical suspension to hang from a variety of different base materials. THE APPLICATIONS SUITABLE AREAS OF USE INCLUDE, BUT ARE NOT LIMITED TO: Long cable tray and cable basket runs. Off-shoots from the primary containment. Light fittings. Radiant heat panels. Chilled beams. Acoustic boards. Plenum boxes. Long suspensions up to 10 m. AREAS FOR USE The Try-Lock system is designed for indoor applications. Regular galvanised systems should not be used in areas that have levels of corrosion or elevated levels of heat or moisture. For installations that are within corrosive areas consult with Zip-Clip Technical Department. INSTALLATION Example installation onto cable basket is carried out at ground level: Open gate of carabiner and hook around upright wire of cable basket. Repeat on opposite side of basket. Ensure angle is 60 degrees or less. Offer basket up to pre-installed vertical wire suspensions. Link to vertical suspension with a Zip-Clip locking device by feeding wire through PVC loop and returning wire back into Zip-Clip device. Trim wire leaving a minimum 15 cm tail. Example installation onto plenum box: Clip carabiners into available connection points, e.g. through holes. Ensure the intended fixture will accommodate the carabiners. If no connection points are available, install eye bolts into the service to give connection points for the carabiners.